For 4-stroke motors. Raise and lower trolling and auxiliary motors on power and sailboats with ease. Built especially for new 4 stroke, heavier, high torque motors. Accommodates long or short shaft More...

Retractable. Bolts to transom holding motor safely out of water. Swings down to position for propulsion. 2" thick waterproof laminated mounting board with full ply at bolt holes for added strength. 4 More...

This plate is constructed of tough 3/8" aircraft aluminum and features a design that allows full tilt with dual steering. Powder coated Black or polished finish resists corrosion. All bolts are More...

Features anodized aluminum frame construction, nylon anti-friction washers and corrosion resistant zinc plated fasteners. Polypropylene motor mount offers 14-1/2" of vertical adjustment. Includes More...

Are a fixed height mount for an auxiliary or trolling motor. Tough 18-8 stainless steel brackets. 1-1/2" thick, 8" wide. For motors up to 15 hp.

Waterproof laminated mounting board with full ply at bolt holes for added strength. Large stainless steel flat 1-1/8" head elevator bolts. Husky secured stainless steel torsion springs help More...

Adds strength to boat’s transom by evenly distributing forces during fast starts, high speed runs and sharp turns. Quality cast in Almag 35 aluminum for non-corrosive strength. Black. 12" bolt More...

The pump and motor are mounted inside the jack plate body. Saves space and installation time.No addtional lines or pumps needed. Patented design utilizes stainless steel support rods tested to exceed More...

The jack plate that can be adjusted from inside the boat with one screw. No side hardware to loosen! Just turn the adjustment screw to the desired height, tighten the locking nut and you are ready to More...